Assembly

Assembly Instructions

click diagram to view animated assembly Assembly Simulation requires Flash Player v6. If you suspect that you do not have it, or the simulation fails to run properly or at all, then click here to install it.

Insert the threaded end of ground stake (part A) into the bottom of the bait tray (part B). Screw the support rod (part C) onto the ground stake securing the bait tray securely between the ground stake's rubber washers and the support rod. The ground stake's double rubber washers will create a tight seal preventing liquid baits from leaking out of the tray. Place your poisonous or non-poisonous baits into the bait tray. Click here to perform search on snail/slug baits Screw the hood (part D) onto the support rod. Do not over-tighten the hood so that empying the trap is hassle free. Insert the assembled Snail Jail™ into the ground in the desired location. Check daily or as often as neccessary, and dispose of the pests. Reload the Snail Jail™, and reset the trap.